How to Install Golf Cart Lift Kit | Club Car Precedent

Instructions

Front Lift Installation

·        Raise the front of the golf cart with a jack and place jack stands on each side of the front end.

·        Use a socket to loosen loosed the lug nuts on the front end and remove the both front wheels.

·        Loosen and remove the tie rods.

·        Use a socket to loosen bolts on factory spindles and remove the factory spindles.

·        Install the new spindles and replace the tie rods and wheel hubs in the same place they were removed from.

·        Be sure to relubricate all joints to avoid squeeks after installed.

·        Adjust the wheel alignment as instructed by golf cart lift kit instructions.

Rear Lift Installation

·        Raise the rear end of the golf cart with a jack and use the jack stands to support the rear end.

·        Remove bolts on the bottom of the shocks where they attach to the axle.

·        Remove the ground straps from starter if it is gas.

·        Use the jack to support the axle and remove U-bolts on one side of the golf cart that were installed by the factory. Remove the leaf spring.

·        Reinstall the leaf spring from the bottom of the axle to the top of the axle. Place the axle lift blocks on top of the the axel between the leaf springs and the axle and replace the factory U-bolts with the new longer U-bolts. Tighten all bolts on that side of the golf cart.

·        Repeat procedures for the opposite side of the axle and tighten all bolts.

·        Install the shocks to the U-bolt plates and tighten.

Tire Installation

·        If you have installed a six inch lift kit with the original leaf springs you will be able to add tires that are 22x11x10 or 22x11x12.

·        If you have installed a six inch lift kit with heavy duty leaf springs you will be able to add tires that are 23x11x10 or 23x11x12.

Mark Dixon

King of Carts, LLC- Golf Carts
Columbia, South Carolina
http://www.kingofcarts.net
(803) 238-2250